Why Do Honda Civic Brake Lights Won’t Turn Off? How To Fix It!

The brake lights of your Honda Civic speak for your actions while running on the road. During this time, if your Civic’s brake light does not function well, the risk of an accident can increase. But why do Honda Civic brake lights won’t turn off and how to fix it? 

The most common reasons the brake lights won’t turn off are faulty wiring or sensors, brake assembly issues, or low brake fluid level. Some issues are very simple to fix, while some are difficult because of sloppy car parts.

This article aims to keep you informed about why brake lights not working and how to troubleshoot the problem. Jump into depth!

Honda Civic Brake Lights Won’t Turn Off

As a driver, if you find any issue with your Honda Civic third brake lights such as it won’t turn off, there are some issues. It is very dangerous for your life and your car and motors.

So if any problem is found, it shouldn’t be neglected. It has to be fixed fast, but before you need to know why the brake lights won’t turn off. 

7 Key Reasons for Honda Civic brake lights won’t turn off: 

1. Defective Brake Switch: 

If the brake light’s switch isn’t working in good condition, the brake light stays on. An effective brake switch must be fixed or replaced to avoid any accidents. If the brake switch becomes older, you must replace it and install a new Honda Civic brake light switch. I prefer to use the HERCOO Brake Stop Light Switch because it is highly compatible with 2001 to 2013 Honda Civic.

2. Stuck Brake Pedal Spring: 

When the brake pedal is stuck and not close enough to switch, the lights won’t go off. The main reason for this is that the spring loses power back to its default position. 

The brake lights will remain on until you connect the pedal and switch. You need to contact a professional service to resolve this problem.

3. Faulty Wiring: 

Sometimes with faulty wiring, the brake lights won’t turn off. If you tried every basic attempt to fix the brake lights, and still it stays on, there may be a big issue. In this situation, you have to go to a professional technician.

4. Switch stopper issue: 

Another reason brake lights won’t turn off is Honda Civic brake light switch stopper issues. If the stopper is missing, you should scan the floor of your car. If you don’t find it, you need to replace it. 

5. Bad Electric system: 

A worse electric system is another significant issue. Check the electric lines and ensure everything is working as it should. 

6. Faulty fuse diagram: 

This diagram is drawn on the lid of the box which will assist you in locating the brake fuse. If you find it, check if it is blown out. If it is, you have to replace it with a Honda Civic brake light fuse such as Genuine Honda Multi Block Fuse. 

7. Socket Issue: 

If the above points seem to work, the last option is to check if the socket is dirty or corroded. The wiring also may have worn out to the point that it can make a middle link responsible for turning on the brake lights.  

How To Fix Honda Civic Brake Light Won’t Turn Off? Easy 6 ways to solve the issues

When your Honda Civic brake lights don’t turn off, there are some common issues you can fix yourself, which makes your problem a solution in the first stage.

Easy 6 ways to solve the issues:

Solution 1: Repair The Brake Lights Switch

Disconnect the battery before working on the car’s electric system to avoid shock. 

• Slip the cable off and tuck it to the side of the battery. Locate the negative terminal and disconnect it.
• Trace the damaging terminal and detach it.
• Use a socket jerk to lose the nut getting the cable to the battery terminal. 
• Locate the brake pedal switch and disconnect the wiring pigtail 
• Now inspect it for damage
• Check the return of the switch and ensure it is working perfectly.

Solution 2: Replace New Brake Lights Switch

The brake light switches are the two-way mechanism near the brake pedal. It can complete the light circuit in the car’s electric system that has to be replaced while it is defective. How to install it?

• Disconnect the pigtail hitch and tuck it away for safety before removing the brake lights switch so that you can reuse the same pigtail hitch later
• Remove the brake switch from the pedal linkage.
• Reuse it and install the new brake light switch (Remember, don’t lose the top hardware)
• If the harness is released accidentally, use the electric tape to hold it in place while installing it.

Solution 3: Replace Blown Fuses

Find out the fuse boxes using the manual guide. One is under the hood and another is on the driver side of the cabin that contains the fuses that need replacement.

Based on your car’s model, remove the interior trim parts and access the fuse box. You also must inspect more than one blown fuse for the brake blown light. 

Solution 4: Disengage The Car Battery

If your Honda Civic parking brake light stays on or isn’t working, you need to drain the battery. To fix it, detach the battery when your car is off while you can encounter this problem. 

It not only stops the brake light from being trapped but also helps to save the battery power to start your car until the problem is rectified.

Ensure the hood latch isn’t electric before disconnecting the negative terminal. If the brake lights still don’t turn off, you have to make sure to test the brake right away.

Solution 5: Clean the Brake Socket & Pedal

A dirty connection or worn wiring makes the socket go amiss, and your Honda Civic brake light does not turn off. So clean out the sockets to save the brake lights from getting trapped. 

If it isn’t working after cleaning the sockets, replace them by snipping the older wires or linking them with a new unit like the Dorman Honda Civic brake light socket. 

A dirty brake pedal is also responsible for which your 2005 Honda Civic brake lights won’t turn off. It may be the cause of a defective rubber stopper or rust between the switch and pedal. 

To protect from it, keep cleaning the brake pedal and even corrosion-free. If the cleaning process doesn’t work, you should contact professional service.  

Solution 6: Replace Honda Civic Brake Lights

Here is how to replace the brake light bulb on Honda Civic from 2006 to 2012 and how to turn off the brake lights Honda Civic. 

• Take a flathead screwdriver and open the two screws.
• Get out the counterclockwise that holds the brake light. Though pretty tough, take it out using a plier.
• Now grab it in two hands and get out the light from the housing simply.
• Check the bulb and know its size and features so you can get a new one with similar features. Here I recommend picking new Honda Civic brake lights. (If there are three wires, you should take double flare light).
  
  Alla Lighting LED Bulbs could be one of your first priorities due to its super bright pure red color. 
  
  Besides this, you can install the Alla Lighting Upgraded Version. Also, you can check out alternative Brake Light Bulb from AUTOONE brand. 
• Connect the new bulb and take it off the same way you can get out the cable. Here you need to push simply to link the light properly.
• Go to the clip’s hole and fix the clips again using a screwdriver or your hands simply. That’s it. If you need to change another brake light, do it similarly. Enjoy your new brake lights and save your car from any accident.

Frequently Asked Questions (FAQs):

My final Opinion

The brake light is an important part of your Honda Civic, but it is a big problem when the lights won’t turn off. Most significantly, you are in risk condition while the brake light won’t turn off. 

You can reduce the chance of an accident by fixing or replacing the brake light. For brake light replacement, I suggest you try iBrightstar Newest LED Bulbs with Projector Replacement. 

I hope the above solutions to fix or replace the brake lights are very helpful to you, and that you can reduce the risk of an accident.